Originally posted by Dave K
View Post
Announcement
Collapse
No announcement yet.
Im lost without the PW thread!!!!
Collapse
This topic is closed.
X
X
-
There are two 1/0ga inputs on the fused block I sent you, but the ground has to be equal to the B+. So if the draw requires two 1/0 cables, then you need to also use two 1/0ga ground cables. Does your ground block also have dual 1/0 inputs?Originally posted by bryce2320 View PostIs there not two 1/0 gauge outs on it? Id have to look again but I assume not from your post. 1 should be fine then huh?
From a cost standpoint, it would be less expensive to just give the slash its own 4ga B+ and GND and fuse holder at the battery/switch.Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More
Comment
But I might as well not skimp on 50 dollars of wire after I blew so much on everything else
Comment