Gatorstep Pricing? Alternatives?

[kdammen]

Here is the stuff I used. I needed 4 sheets. It takes a lot of planning to get all the patterns to line up between parts. Total cost this route was about $550.
https://www.amazon.com/KT-GuoMei-Sel.../dp/B09H4GSS46

So far I'm happy. Definitely more work adding the contact cement, but I didn't want to gamble with their adhesive.

[pjku79]

Following, just bought an 2007 rz2

[Grebva3]

I have a 2012 RZ4 and am on RD4 of gator step sizing doing the whole boat with a couple of custom pieces. I’d wait for a sale and you could likely get 1-200$ off that price. Just my thoughts.

[retox1]

Here is the stuff I used. I needed 4 sheets. It takes a lot of planning to get all the patterns to line up between parts. Total cost this route was about $550.
https://www.amazon.com/KT-GuoMei-Sel.../dp/B09H4GSS46

So far I'm happy. Definitely more work adding the contact cement, but I didn't want to gamble with their adhesive.

Did you leave a way to lift up the floor for access?

[kdammen]

I have one seam that runs along the starboard side of the floor access hatch. I figure if I need to lift the floor I can easily cut a slit around the rest of the hatch.

[retox1]

I have one seam that runs along the starboard side of the floor access hatch. I figure if I need to lift the floor I can easily cut a slit around the rest of the hatch.

Thanks, I couldn’t see the seam so I was wondering. I’d love to do this to mine as well, but working around that floor hatch makes me a little nervous. I pull my floor up pretty often, i usually clean under there at the beginning or end of the season.

[kdammen]

The floor in this boat is a pain to work with, but the eva is so much better than carpet. If you haven't seen it I have the writeup at wake garage. The hatch could easily still be removable with the seam cut along it.

https://www.wakegarage.com/projects-...-install-r335/

[lightadjust2000]

I have a 2009 22ve. How do I remove the old platform decal/layer which is very uncomfortable to prep and put down ultradeck or gator step, etc?

[kdammen]

I believe I just ripped it up with a pliers. I may have used a heat gun to soften the adhesive.