Raising the V drive floor plate in a 2007 20v

[Bandsecurity]

Does anyone know how to do this? I cannot figure it out and prying it with a screw driver does not see to work

[kko]

the center of the rear seat has to come out. there are two screws on the rear of the floor plate holding it down. what are you after?

[Bandsecurity]

just want to make sure that they properly secured my skegs after fixing them

[Bandsecurity]

exploring a little also

[whitlock87]

the center of the rear seat has to come out. there are two screws on the rear of the floor plate holding it down. what are you after?

this is the same for my 2004 switch -v ( same hull as your boat)
(You will have to remove the cartpet stip from along the bench to remove the center peice)

If you need it, I can take a few pics and post them.
David W.

[whitlock87]

just want to make sure that they properly secured my skegs after fixing them

On your boat they are lagged, and not through bolted.
So you can check it from under the boat.

[Bandsecurity]

some have said lagged and others through bolted. That is why I am concerned. I would like some picks. I wish I knew for sure.

[whitlock87]

When tige changed the way they made the hulls, (new composite floor) they changed the way the skages bolted.
this was back in 2003 or 4
or so i belive

[dogbert]

some have said lagged and others through bolted. That is why I am concerned. I would like some picks. I wish I knew for sure.

Even if you remove the floor, you will need to remove the gas tank to get to see where they are mounted.

[spharis]

Contact Tige' or lee. They will know the crossover years.

[tobo57]

My 03 21i was the last year for the excell[plywood type] flooring.Also the only year for the lifetime plus $10,000 warenty.At least that is my understanding.