Perfectpass paddlewheel

[scootc]

It looks like I'll have to replace the paddlewheel assembly. Does anyone have pictures of the paddlewheel assy? Is the wire/cable permantely attached to the assy, or does it unplug? The reason I ask is it woud be nice if I didn't have to re-run the cable all the way back to the module. The PP install manual doesn't show any of this.
Thanks.

[joe8395]

Mine unplugs.

[Tip]

Do you need to replace the entire paddle wheel housing or just the paddle wheel itself? If you are just replacing the wheel then no rewiring is needed. I had to replace my wheel when one of the paddles broke off (don't ask, I was an idiot) If you are replacing the entire housing you will need to unplug the entire wire from the back of the PP head unit and rerun the wire. Your only other option is to splice the wire back near the wheel housing. I do not recommend splicing the wire because you may affect the signal from the wheel housing to the PP head unit.

Tip

[scootc]

Thanks for your replies. I actually tried another system master reset, and it started working Strange because this didn't work before. I'm crossing my fingers that this is all that was needed.