Ok was back out yesterday and things were good then while surfing boat would try to stall. We would loose speed then after a a few seconds back to normal. It happened maybe 5 times that day also had my two beeps back which we thought was the fuel pump relay. Would being too bow high cause this? If it were leaned to much would it sense low oil pressure and cut the power? Im not sure what to check as it was very inconsistent when it happened.
-
-
to much bow rise or lean could do that depending on wer your paddle wheel is at ,it may not be in the water the whole time i had a 21i that occ did that till i started bringing the bow down a bit.
surf till u die. -
That two beeps is still either a bad sensor or open/short circuit for one of the ecm functions. Did you ever get it scanned?Fixing everyone elses boat just so I can use mine...Comment
-
yeah I had it scanned and only thing we found was fuel pump relay which I replaced and now it does not continue to run after I shut the motor off. We went back out today and surfed for about 3-4 hrs and no beeps and no cutting out? Only difference was we had more fuel. Do you think it is from too much lean or bow rise and maybe making the oil pressure fluctuate making it think it has low oil pressure and cutting the power? Only other issue I have seen is it died once at idle after a surfer fell and I slowed down to turn around and put it in nuetral. Seems like the rpm's drop below 600 for a second and then come back up.Originally posted by boatwakes View PostComment
Comment