My amp install

[rushin]

A Kicker 650.4 & Kicker 700.5 with power and ground distrobution blocks.

[chpthril]

Looks real good, I like the end caps

[da.bell]

That looks like a familiar spot Best place for them IMO...

[larryueckert]

very clean and way cool

[NICKYPOO]

Nice Dude!

[sparky216]

wanna come and do mine?

Nice

[talltigeguy]

That is the outside wall, right? How did you attach the board to the hull?

[da.bell]

There should be braces that come off the inner hull about 4-5 inches. There is some plywood that is attached to the braces by "L" brackets and the amps are attached to the plywood.

[talltigeguy]

There should be braces that come off the inner hull about 4-5 inches. There is some plywood that is attached to the braces by "L" brackets and the amps are attached to the plywood.

What glue did you use to attach the braces? I don't think you would screw into the fiberglass of the outside hull, would/could/did you? What specific glue is the question...assuming a glue was used.

[chpthril]

What glue did you use to attach the braces? I don't think you would screw into the fiberglass of the outside hull, would/could/did you? What specific glue is the question...assuming a glue was used.

Liquid nails, Gorilla Glue (watch out, it expands alot), PL400 (contractor grade stuff). Once you figure out where you need to place the amp racks mounts/pedestals, cut away the carpet, clean the spot as best as you can, then glue down the mounts. You will get a much better hold, if you can wedge something against the mounts to apply pressure while the adhesive sets, like clamping any other wood project.

[da.bell]

What glue did you use to attach the braces? I don't think you would screw into the fiberglass of the outside hull, would/could/did you? What specific glue is the question...assuming a glue was used.

Look at the first two postings on http://www.tigeowners.com/forum/show...t=6270&page=12. You can see that the pictures have a small "L" bracket located in the bottom left of the amp rack.

[rushin]

Yes, that is the outside wall however it is not actually mounted to it but mearly up against it. Like da. said there are 2 hull supports that come out from the hull, one forward that the bow seatback strut is mounted to and one aft that is to the left in the picture. The rack fits in between them snug with the carpet. Then I used "L" brackets to secure the rack to the hull supports.