Im lost without the PW thread!!!!

[Bruizza]

Good evening halfwatt!

[skippabcool]

I love a nice short lawn and I water the heck out of it. I usually mow at least once a week, sometimes twice...
I should have mowed tonight, I'll mow tomorrow and again on Monday

Mine is not real grass. It is Colorado grass. Our water is expensive and they actually don't like us watering much. I have a 10 x 20 of real grass and that is it.

[Timmy!]

Didn't get my lights yet but used a couple of 5mm led's to try this out.

[Timmy!]

here's another shot:

[Timmy!]

My buddy found a place near his work that has the .375 translucent white so he is going to pick some of that up to try. I think that would work and look a little better.

[halfwatt]

Skippa if u wanna mow a lawn, I've got a good sized back yard your welcome to!
There's a reason they call Linn county the grass seed capital!

[Bruizza]

Timmy I'm going to need you to just go ahead and make 2 sets of these led rings!

[halfwatt]

x3

[Timmy!]

LOL! You'll have to get in line Bruizza! I posted it on FB the other day and between texts and FB, if I can get them to come out nice, I will be making about 100 of them. HAHAHA!

[Timmy!]

I think chpthril is making them already, he probably has his process down to a science. I made a jig for my drill press for drilling the center hole the same in each one, a jig for the router table for cutting the circles and next I need to make something for my sanding station so I can polish the edges up nice and pretty consistently.

[Timmy!]

Oh and I need to put the sanding drum on the drill press so I can clean up the insides too.

[skippabcool]

Skippa if u wanna mow a lawn, I've got a good sized back yard your welcome to!
There's a reason they call Linn county the grass seed capital!

I have mowed plenty over the years and and my yard is not small.

[chpthril]

I think chpthril is making them already, he probably has his process down to a science. I made a jig for my drill press for drilling the center hole the same in each one, a jig for the router table for cutting the circles and next I need to make something for my sanding station so I can polish the edges up nice and pretty consistently.

Yep, my process is scientific......I call my plastics guy across town and tell him how many I need and he cuts them out

I do cut the bulk LED strips and solder the wires on though

[skippabcool]

Timmy is busy

[Timmy!]

Yep, my process is scientific......I call my plastics guy across town and tell him how many I need and he cuts them out

I do cut the bulk LED strips and solder the wires on though

Much easier...