Im lost without the PW thread!!!!

[skippabcool]

What happens if you place the wire back on the acc. side again. Same effect?

I really can't do that since I switched connectors (screw to a female slide).

[skippabcool]

I am going to check my batteries and make sure they are charged and have good connections.

[skippabcool]

I did check this thread out.

http://www.tigeowners.com/forum/showthread.php?p=427178

[skippabcool]

Ugh, I have to go to Houston tomorrow night to see RT.

You should be excited.

[mls6722]

all my hoses run. I have to drill the last drain/vent thruhull - the baot needs to come out of the garage and I didn't have the tow vehicle today.

then I need to install all the panels and wire the switches and it is done.

And.........I see the charge showed up for my FAE, so it must be ready to ship

[Iwndr]

You should be excited.

I'm thinking he's closer to San Antonio

[skippabcool]

all my hoses run. I have to drill the last drain/vent thruhull - the baot needs to come out of the garage and I didn't have the tow vehicle today.

then I need to install all the panels and wire the switches and it is done.

And.........I see the charge showed up for my FAE, so it must be ready to ship

Sounds like your making progress.

The never ending boat list

[Iwndr]

all my hoses run. I have to drill the last drain/vent thruhull - the baot needs to come out of the garage and I didn't have the tow vehicle today.

then I need to install all the panels and wire the switches and it is done.

And.........I see the charge showed up for my FAE, so it must be ready to ship

Sweet! I even drilled a hole in the Zee today

[skippabcool]

I'm thinking he's closer to San Antonio

He'd make a run down to see you, unless you made him mad.

[skippabcool]

Sweet! I even drilled a hole in the Zee today

For what? Where are the pics?

[mls6722]

Sweet! I even drilled a hole in the Zee today

not through the gas tank I hope

[lancehon]

all my hoses run. I have to drill the last drain/vent thruhull - the baot needs to come out of the garage and I didn't have the tow vehicle today.

then I need to install all the panels and wire the switches and it is done.

And.........I see the charge showed up for my FAE, so it must be ready to ship

Nice work

[Wakeman22]

Nite all.

Its late and I'm out.

[skippabcool]

Nite BigW

[lancehon]

all my hoses run. I have to drill the last drain/vent thruhull - the baot needs to come out of the garage and I didn't have the tow vehicle today.

then I need to install all the panels and wire the switches and it is done.

And.........I see the charge showed up for my FAE, so it must be ready to ship

I tee'd my vent and drain lines so now I only use 1 stock thru hull per side. Could you do the same and not have to drill new holes?