Watcha think rocket scientists???

[wannabewakeboarder]

Hahaha Your right there, thats what my dad tells the tube "victims"

[R&T Babich]

I stick with the "TOW HOOK"

Are you talking about the transom eyes on the back of the boat?
Our boat didn't even have reinforcing plates behind the transom eyes.
Our transoms are only 7/8" or so. The transom on our '75 Cobalt was 1 1/2" 31 ply.
The transom eyes are great for trailer tie downs.

[zad0030]

Are you talking about the transom eyes on the back of the boat?
Our boat didn't even have reinforcing plates behind the transom eyes.
Our transoms are only 7/8" or so. The transom on our '75 Cobalt was 1 1/2" 31 ply.
The transom eyes are great for trailer tie downs.

No, I have a hook built in with the grab handle, thats bolted down in 4 places and the transom is 1 1/4" thick.

[R&T Babich]

No, I have a hook built in with the grab handle, thats bolted down in 4 places and the transom is 1 1/4" thick.

I haven't seen one of those. Sounds like it would work fine. Our Cobalt had a "tow hook". It was bronze and was basically a bolt thru the transom with a hook on the end. Bent it over a few degrees pulling tubes.

[R&T Babich]

... the transom is 1 1/4" thick.

You're also right in the center of the transom it's thicker, at least on the 21V. When I replaced the transom eyes with longer ones with plates the transom is thinner there.

[zad0030]

I haven't seen one of those. Sounds like it would work fine. Our Cobalt had a "tow hook". It was bronze and was basically a bolt thru the transom with a hook on the end. Bent it over a few degrees pulling tubes.

Its one of these bad boys...