Announcement

Collapse
No announcement yet.

Hour meter not working

Collapse
X
Collapse
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
    #16
    Your gauges would have buttons, speed set has nothing to do with it. Sorry for the confusion, I though the Z1 had the same level of gauges that the Ve and RZ boats have. Similar to this, except Medallion not faria. Those buttons, along with ones on the other gauge, navigated through sub menus.

    Last edited by chpthril; 08-27-2015, 11:17 PM.
    Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

    Comment

      #17
      Originally posted by chpthril View Post
      Your gauges would have buttons, speed set has nothing to do with it.
      Strange thing is my manual describes changing some readings to get water temp, hours, etc using speedset buttons with cruise toggle off. But on same note it doesn't show an accurate drawing of my cluster either. Thus my confusion!
      2008 Tige Z1 Limited Ronix Edition
      360 hp, Fly High ballast, Alpine, JL Audio, Kicker, Wetsounds audio

      Comment

        #18
        Pulled wires off and put a multimeter on them. 12v when engine is running. So it's one of 3 things.
        1- Wires were pulled off and put back on backwards
        2- a good connection was not being made (seemed tight)
        3- gauge is shot.

        I'll be doing some testing if I get boat out again this fall.
        2008 Tige Z1 Limited Ronix Edition
        360 hp, Fly High ballast, Alpine, JL Audio, Kicker, Wetsounds audio

        Comment

        Previous 1 2 template Next
        Working...
        X