Ok guys,
2007 20v with MEFI5 ECM.
Diacom is showing DTC codes of SPN 636, FMI 2 Crank Signal Fault (Crankshaft Position (CKP) Sensor Circuit Signal Fault)
and SPN 66014, FMI 4 Powertrain (MEFI System) Relay Contact Low.
Diacom also shows several values down in the "Misc Status Flags" section but I'm having trouble finding a reference for those. I'm seeing 4.0 (which, I believe, is normal), 132, 196 and 206. While at speed the Misc Status Flag 196 was pretty much continuous. At some point, the 206 flag instantly appears and the boat beeps the warning horn and abruptly reduces to idle RPM. If you then manually come to idle (in gear) then back to forward power, it acts like nothing is wrong (goes back to 196 flag) until it throws the 206 flag again.
Does anyone have a reference for what these Misc Status Flags are?
I replaced the Cap/Rotor/Wires/Plugs and the Crank Position Sensor and all of the codes and misc status flags have cleared up but I would like a reference to see what the ECM was unhappy about. I can see plenty of detail on the DTC codes but nothing on the Flags.
Anyone?
Thanks! Jimmy
2007 20v with MEFI5 ECM.
Diacom is showing DTC codes of SPN 636, FMI 2 Crank Signal Fault (Crankshaft Position (CKP) Sensor Circuit Signal Fault)
and SPN 66014, FMI 4 Powertrain (MEFI System) Relay Contact Low.
Diacom also shows several values down in the "Misc Status Flags" section but I'm having trouble finding a reference for those. I'm seeing 4.0 (which, I believe, is normal), 132, 196 and 206. While at speed the Misc Status Flag 196 was pretty much continuous. At some point, the 206 flag instantly appears and the boat beeps the warning horn and abruptly reduces to idle RPM. If you then manually come to idle (in gear) then back to forward power, it acts like nothing is wrong (goes back to 196 flag) until it throws the 206 flag again.
Does anyone have a reference for what these Misc Status Flags are?
I replaced the Cap/Rotor/Wires/Plugs and the Crank Position Sensor and all of the codes and misc status flags have cleared up but I would like a reference to see what the ECM was unhappy about. I can see plenty of detail on the DTC codes but nothing on the Flags.
Anyone?
Thanks! Jimmy