Hi ALL,
Just purchased a new to me 2012 Tige RZ4. Cleaning it up and getting it ready.
I put in 2 new batteries thinking it might be a low voltage issue, but no luck.
Issue#1
when I turn on the power cut off switch in the read the heater comes on full.
I can select the heater on the tige touch and toggle low/hot/off but nothing happens it stays on.
I pull the fuse on the main board under the helm and it turn off. Put fuse back on and it starts again.
key out of ignition and heater still runs.
Ideas??
Issue #2
when I toggle the taps button on the throttle I can hear the motor in the rear on the starboard side behind the access panel work and make a pump sound.
But the plate in the rear does not move, and the gauge does not change just stuck on 4.
The boat is on the trailer. Does it need to be in the water?
ideas??
Thanks anyone.
Excited to get her in the water just want everything 100%. Use to own a wakesetter and thus far really happy with the Tige ex wot for these 2 issues.
Just purchased a new to me 2012 Tige RZ4. Cleaning it up and getting it ready.
I put in 2 new batteries thinking it might be a low voltage issue, but no luck.
Issue#1
when I turn on the power cut off switch in the read the heater comes on full.
I can select the heater on the tige touch and toggle low/hot/off but nothing happens it stays on.
I pull the fuse on the main board under the helm and it turn off. Put fuse back on and it starts again.
key out of ignition and heater still runs.
Ideas??
Issue #2
when I toggle the taps button on the throttle I can hear the motor in the rear on the starboard side behind the access panel work and make a pump sound.
But the plate in the rear does not move, and the gauge does not change just stuck on 4.
The boat is on the trailer. Does it need to be in the water?
ideas??
Thanks anyone.
Excited to get her in the water just want everything 100%. Use to own a wakesetter and thus far really happy with the Tige ex wot for these 2 issues.