Results 1 to 7 of 7

Thread: 1999 21V Rear Locker Panels

  1. #1

    1999 21V Rear Locker Panels

    Recently bought a 1999 21V that is missing the panels in the rear locker. I've been looking around the web for either a used-parts site, but had no luck. I figured I ask before I start building a custom set.

    I'm looking for the following:

    • port and starboard panels on the rear lockers
    • Upright U-Channel on the starboard stern side
    • panel on the stern starboard side where the shower should be and the u-channel for the engine panel mounts to


    Thanks

  2. #2
    Join Date
    Dec 2015
    Location
    Denver, CO
    Posts
    978
    Boat
    2007 22ve
    I’d be willing to bet you’re on your own.
    You can get U channel all over online or at Home Depot, Lowe’s, etc.. (I’d go with aluminum if you’re putting ballast bags in there). Lots of people are reinforcing their panels vertically as well to avoid bowing panels.
    1/2” hdpe can be sourced on eBay fairly affordably and easily cut to size.

  3. #3
    21v hatchp.png
    The hatch pockets?

    21v bulkhead.png
    Rear Bulkhead?
    Grumble, Grumble

  4. #4
    Quote Originally Posted by Jetdriver View Post
    I’d be willing to bet you’re on your own.
    You can get U channel all over online or at Home Depot, Lowe’s, etc.. (I’d go with aluminum if you’re putting ballast bags in there). Lots of people are reinforcing their panels vertically as well to avoid bowing panels.
    1/2” hdpe can be sourced on eBay fairly affordably and easily cut to size.
    Thanks for the HDPE tip

    Quote Originally Posted by KoolAid View Post
    21v hatchp.png
    The hatch pockets?

    21v bulkhead.png
    Rear Bulkhead?
    Missing the bulkhead on the starboard side.

  5. #5
    Quote Originally Posted by 21V View Post
    Thanks for the HDPE tip



    Missing the bulkhead on the starboard side.
    Do you have cad or know someone with a cnc router?
    Grumble, Grumble

  6. #6
    Quote Originally Posted by KoolAid View Post
    Do you have cad or know someone with a cnc router?
    I have access to cad, no access to CNC though. If you can share the file or general dimensions I could figure something out.

  7. #7
    im me your email address.
    Grumble, Grumble

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •