Results 1 to 5 of 5

Thread: Excessive water

  1. Excessive water

    Never had this issue until today, went out on the lake after about 4 hours on the lake the bilge pump couldn’t keep up and at throttle I had water entering thru the floor. Any help on where to start, plug was in, didn’t fill the ballast tanks. It’s a 05 tige 24v

  2. #2
    Try taking up floor and and middle back seat and check manifold where pumps are. I had this before and manifold was not glued together in one spot. Easy fix.


    Sent from my iPhone using Tapatalk

  3. Okay I’ll look today, I’m going out in a hour

  4. #4
    Join Date
    Sep 2016
    Location
    Richmond, VA
    Posts
    2
    Boat
    2000 21V / Dorsey Trailer
    Check for a leaky prop seal. If toast replace.


    Sent from my iPhone using Tapatalk

  5. #5
    Join Date
    Mar 2004
    Location
    Minnesota- regretably...
    Age
    52
    Posts
    69
    Boat
    Tige 21v 2001
    The shaft seal can come loose- it's a compression fitting- 3 hex headed nuts- push in down as tightly as you can get it and reseat the screws. Mine's worked its way loose 2 X in 18 years. I check it every summer now. It will only take on water when you're underway- so diagnosing while sitting in the lake doesn't do you any good.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •