Results 1 to 4 of 4

Thread: 2011 rz4 stock power

  1. #1

    2011 rz4 stock power

    Looking to clean up my stock amp rack. Don't want to run new trunk just want to put existing 2 pair of power runs on distribution blocks. I can't see what size wire was used from factory but it doesn't fit well into the syn2 and syn-dx6 inputs. Does anyone know what they are? Looking for some simple Tpec options.

    Thanks

    Sent from my Pixel 2 using Tapatalk

  2. #2
    Join Date
    Apr 2006
    Location
    Lake Wylie area, NC
    Age
    49
    Posts
    27,252
    Boat
    Back in the good ol' days a 2006 22ve
    I think its either 8 or 6 gauge.
    Mikes Liquid Audio: Knowledge Experience and Customer Service you can trust-KICKER WetSounds ACME props ARC Audio FlyHigh Custom Ballast Clarion LifeForm LED Polk Rockford And More

  3. #3
    Looks like Pacer SAE No. 4

    Assuming 4ga.

    This is what I need to clean up.

    Sent from my Pixel 2 using Tapatalk

  4. #4
    Join Date
    Apr 2006
    Location
    Lake Wylie area, NC
    Age
    49
    Posts
    27,252
    Boat
    Back in the good ol' days a 2006 22ve
    If the insulation says 4, then that would be 4ga. Those amp are designed to accommodate 4ga. The issue is when the end is allowed to mushroom. Fresh stripped cable will fit in cleanly.
    Mikes Liquid Audio: Knowledge Experience and Customer Service you can trust-KICKER WetSounds ACME props ARC Audio FlyHigh Custom Ballast Clarion LifeForm LED Polk Rockford And More

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •