Results 1 to 6 of 6

Thread: 2018 RZX2 PNP question

  1. #1

    2018 RZX2 PNP question

    I have pnp installed in my 18 rzx2. When I fill the rear ballast to say 60 percent they fill to max and start to overflow.

    So they are at 100 percent but my ballast indicates 60 to 65 percent.

    I let them fill and overflow until the dash indicated 100. I thought this would set the 100 percent so to speak.

    Drained ballast to 0 and then refilled back to 100 percent. They were full again at 60 percent.

    I have adapted to the inaccurate rear ballast percentage as I don’t surf at max full rears.

    Is this a setting issue anyone know what I’ve got going on?


    Sent from my iPhone using Tapatalk

  2. #2
    Join Date
    Jan 2004
    Location
    Mount Juliet, TN
    Posts
    2,551
    Boat
    Tigé
    You can change the ballast timers.

  3. #3
    Join Date
    Jul 2015
    Location
    Orange County
    Posts
    1,717
    Boat
    2019 ZX5/ZX1
    Settings, ballast, timers

  4. #4
    I did change the timers. I increased the time when I added the pnp.

    I will shorten timer length on fill.

    I’m guessing from the replies the timer determines the percentage it indicates full.

    Thanks.


    Sent from my iPhone using Tapatalk

  5. #5
    Join Date
    May 2012
    Location
    San Angelo, TX
    Posts
    814
    Boat
    2015 Z3 w/AVX
    Quote Originally Posted by robricketts View Post
    I’m guessing from the replies the timer determines the percentage it indicates full.
    Correct. Its just a timer. Use a stopwatch to get your correct times and then adjust the timer in the setting section.

  6. #6
    Thanks


    Sent from my iPhone using Tapatalk

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •