PDA

View Full Version : oil capacity


illiniboarder88
03-13-2008, 02:58 PM
Does anyone know if the 5.7 engine block holds 5 quarts of oil, or is it more? I have a 2000 315 HP. I have an old version of that engine in an automobile engine, and it holds 5 quarts. I only ask because some of the newer v8's hold 7 quarts.

spharis
03-13-2008, 03:39 PM
Mine holds about 5 even; I would add 4 and add a half quart until I had it full. I read my dipstick on the water, or in the drive with the boat level.

Auto 350cid were usually 5 or 5.5 depending on pan size. I had a tahoe with 5.5, and a c/k with 5.

I started running Schaeffer's Moly Blend 40W this season. I'll see how it does.

illiniboarder88
03-13-2008, 03:41 PM
what grade of oil are you running in your boat?

samw
03-13-2008, 04:16 PM
spharis
I am with spharis, mine is 5-5.5 quarts. I also am using a 40W.

Sam

spharis
03-13-2008, 05:33 PM
straight 40 with Moly

scoot18
03-13-2008, 05:39 PM
07 22 Ve with MP 340, service tech from my dealer told me that mine only held 4.5. This arose from questions I had about consumption. Come to find out I was overfiling and thinking the engine was using more that I thought, based upon what I was draining out. I switched to synthetic on last change and not sure if that has helped. Best to add & check as you go to find out exactly the amount it holds.

Jason B
03-13-2008, 06:24 PM
I'd measure how much you took out and start there (assuming it was at a good level before you drained it). Just check the dipstick after adding the last few quarts and you'll be fine.

yllw20
03-13-2008, 06:32 PM
my 03 20i holds 5 quarts - run the merc synth blend

illiniboarder88
03-13-2008, 10:45 PM
The next issue is figuring out the filter number. The filter on it is a fram, and it is a PH30. The AC Delco equivalent to that is a PF454. There is another AC Delco, the PH1218 or 1214, I can't remember which, that would fit as well. That second AC Delco filter is the filter on most 5.7 GM's of the late 90's and early 21st century. It appears that the filter that is on it was the filter for camaro's in the early to mid 90's. I'll probably just call Tige tommorrow to confirm.

spharis
03-14-2008, 01:04 AM
You can also find a K&N to fit. I think the mobil1 number is 3322. Look up 1997 5.7L camaro or corvette. That's what fits mine.

Tanner
03-14-2008, 01:07 AM
AMSOIL Filters only :)

chpthril
03-14-2008, 01:18 AM
Check it before you drain, put back the same amount you drain, plus what is needed to bring it up to the safe mark.

In other words, if it's low, and you drain 4qts, add 4qts plus enough to bring it back to full. If it shows full, and you only get 4qts out, fill with 4qts.

Dont forget the 1/2qt in the filter.

illiniboarder88
03-14-2008, 02:05 AM
Spharis, the thing that I found weird is that two filters fit it, but holds more oil than the other.

chpthril
03-14-2008, 11:32 AM
Spharis, the thing that I found weird is that two filters fit it, but holds more oil than the other.

There is a short and long filter that fits the 5.7L. If you've got the clearance, go with the long.

TRD
03-14-2008, 11:51 AM
The next issue is figuring out the filter number. The filter on it is a fram, and it is a PH30. The AC Delco equivalent to that is a PF454. There is another AC Delco, the PH1218 or 1214, I can't remember which, that would fit as well. That second AC Delco filter is the filter on most 5.7 GM's of the late 90's and early 21st century. It appears that the filter that is on it was the filter for camaro's in the early to mid 90's. I'll probably just call Tige tommorrow to confirm.illiniboarder88, (NAPA : 1069)
If you have excel, I can send you a file that has Napa part numbers for oil filter, oil/water seperator, belt number, oil used, impeller and impeller hsg numbers and my winterizering instructions. You can PM me w/ and email address and I will send what I have.

illiniboarder88
03-14-2008, 12:06 PM
i've got the clearance, and I initially bought the long one. I figured, when in doubt, have more capacity. TRD, thanks! I sent you a PM

TRD
03-14-2008, 12:29 PM
i've got the clearance, and I initially bought the long one. I figured, when in doubt, have more capacity. TRD, thanks! I sent you a PMWhat is the filter name and number if you don't mind?

illiniboarder88
03-14-2008, 01:15 PM
I bought an AC delco PF 1218. The PF 454 will fit as well. The PF 454 is the equivalent to a Fram PH 30. The PH30 is what is on the boat.

TRD
03-14-2008, 02:06 PM
thanks.
I will add that to my sheet.

spharis
03-19-2008, 10:45 PM
I run the high flow K&N filters.