Ouach at 6:00 am

[Original Wing Nut]

It's tigeblues fault. I was too jealuos of him yesterday so, I head out this morning at 5:30 and just as were were ready to start, ouch we found a rock. This is a warning call to all who may use Willard Bay in Utah. I knew it was way down and I had avoided going out until this morning. My boss was coming and his brother had been out on Willard Monday on the south end and said the were 7' deep plus the whole time he was out. We gave it a try because Pineview doesn't open till 7:00 and we were sneaking out before work. OOPS, well like my signature says "Stupid Hurts" I have a 537 acme and I think it can be repaired, but want to try a different prop, so I am going to buy a new one. The 537 is a 13.5 x 16, I want a little more hole shot for when loaded, but don't want to totally kill top end. Suggestions welcome? I now have to get to work to pay for the new prop, although the boss did say he would help, now we'll see how much?

[da.bell]

I would call Acme and talk with them direct. I am sure they can help you out.

That sucks. I did that to my prop 2 months ago. Hopefully your boss does help you out. Tell him you want a raise! ;) Not to mention, tigeblue should palpay you some money also. :D

[dogbert]

I highly recommend the Acme 525 13x11.5. I know it's a big down-pitch, but the thing is huge and pushes a lot of water. You'll really notice the difference when loaded down.

[tigeblue]

I would call Acme and talk with them direct. I am sure they can help you out.

That sucks. I did that to my prop 2 months ago. Hopefully your boss does help you out. Tell him you want a raise! ;) Not to mention, tigeblue should palpay you some money also. :D

:eek: :eek: :eek: :eek:

ack!


kay paso?

me no speekie english

[da.bell]

HA HA HA

:ot: tigeblue, did you head out today? I going out at 5 PM on a friends BU up North Fork.

[tigeblue]

not today. have to work. plus I'm a little sore from yesterday. whats up for Saturday mourning? do I hear a 6 am call in order?

[tigeblue]

plus there has been allot of boats out at noon. Lots of friggin tubers,

I hate tubbers

matter of fact ima post a thread about it right now

[Original Wing Nut]

Hey I borrowed a prop puller and I need some info on how to use it. It is a c clamp style. I have put it on as I thought I should and tightened down the nut and then hit the nut with a hammer. I don't know how hard to tighten it down or how hard to hit it. It is borrowed so I don't want to bugger things up. Thanks for the replies in advance.

[da.bell]

not today. have to work. plus I'm a little sore from yesterday. whats up for Saturday mourning? do I hear a 6 am call in order?

PM sent