Rival Ballast install

[juniors]

Does anyone have pictures of where to make the hole where the fill and drain hoses come up from in the bow?

[Coach]

http://www.tigeowners.com/forum/showthread.php?t=2140&highlight=rival

This thread should answer everything you need to know

[xpjim1]

The drain and vent hoses go from the bag in the bow out the side. I ran the fill hose on top of the gas tank and came up in the storage area before the under bow seat storage. Drilled a hole in front of the vent hose hole, and then in the wall to get the hose to the bow. I will not have pictures until next week. Not sure how Talltigeguy got the fill hose to the bow.

Hope that makes sense.

[juniors]

Ya thats what I was thinking of doing. I can feel a bulkhead in front of my heater hose. I can come up from behind the hose in the storage and then go thru the side.

[talltigeguy]

I initially ran the fill hose up over the engine compartment divider and then along the starboard side all the way to the front.

I just rerouted it on top of the gas tank and then up where the steering cable goes through and then to the front. No extra holes drilled either way.

So mine does make a journey up to the level of the bottom of the dash board. I do not think it has affected fill times at all.