Side Cousion Removal

[Domsz06]

OK, I have a 03 21ir How do you remove the side cousions, aka, the cousions directly on either side of the engine? Like the one's that are next to the outer walls of the hull? I'd like to slip some small ballast sacs there if there is room, so that way They are out of the way. Thanks

Dom

[Domsz06]

come on, some one has to know how. the pic is of the cushion i'm taking about.

Dom

[Domsz06]

here it is

[lee]

Look between the roll and the panel and you should see some stainless screws holding it to the deck.

[jeffro]

hehe, that's a sweet red 21i aint it!! :D

[Banks]

just look at it hard befor you go tearing stuff up. i hate to see the boat get hurt:(

[Domsz06]

so there are some screws holding it in place from the outside that are covered by the vinyl? Is that what you are saying? what do you mean by the roll? thanks guys

Dom

Banks- I don't want to hurt her either, thats' why i'm asking all of these questions.:)

[Domsz06]

jeffro,

is that your boat? I just grabbed it off a google search, since I was not at home with my boat pics;)

Dom

if it is, thanks, you do have a sweet looking boat. I can't wait to get mine tweaked out for the summer:)

[jeffro]

hehe, yah dom, that one is mine. I have it in the gallery here as well as wakeboarder.com, i guess google picked it up.

[lee]

Between the white and the platinum where the seam is, the screws are stuck in crease.

[Tige M.D.]

Dom,
Look under general tech discussion, look for "tower mounts" thread. I explain how to remove the cushions there.
Call me if you still can't get it.

Greg Denton
Service mgr. Tige Watersports
909/737-9801

[Domsz06]

Thanks Doc,

I bet I can figure it out from there. if Not i'll be giving you a call. Thanks again.

Dom

[Domsz06]

i saw the screws friday when I went out. Thanks for the info.

Dom