I have checked all the wiring for voltage and multiple points for continuity. Checked all grounds for continuity off the batteries for sure.

I usually only run on one battery just in case I have any problems, I can switch to the other battery or combine. But to answer your question, No I...

Quick report back. Installed both fuel pumps Friday and hit the lake Saturday. Problem is solved.

So I'm a likely for Weds but solid any other night.

Just started the boat after a week of sleeping.....idled for a bit then at temp, ran to 5K on the Tach...alarm sounded immediately. Pull back on the...

A constant alarm is only one of three things: engine overheat, low oil pressure or high transmission temp. Any one of those would cause the engine to...

The timing is computer controlled, however, if you're replacing or have removed the distributor for some reason, it needs to be mechanically set...

Sounds like a grounding issue.

i had a similar post and issue. Mine cracked on the driver's side just below the light lense in the bend. My dealer pulled a string and they...

i should add, 150 hours on boat

I've been getting the same SFT 4238 code for a month. My dealer came out and did a software update and claimed it to be fixed. I told the tech about...

I know 18cracing sells the custom taps plates and he used to have the same boat I am pretty sure and his wave was great so hopefully he chimes in ...

when you had it on combined were you still having any problems?

I'll let you know tomorrow. I need to fetch the family from Sheerness some day next week. I'm at Sheerness now. Water is mostly 75 but near the...

i would just make sure your temps stay good once you get it in the water, but im guessing youll be fine! Id still replace the impeller at the...

had a rzx2 with the 440, and pnp, about 1400ft put a 2315 prop on it. ran 3400 rpms and had a great hole shot over stock prop. Problem is youre not...

im guessing by horn he means the engine alarm, not the actual boat horn. Especially being he says he is having other issues

Ground is lacking or terminals on either end of the positive or ground cables are dirty.

Gents I have had a major change of plans. No longer going to Montana. It looks like Wed will be nicest day. Does that work for you guys? Sent...

That's the dealer I go through maybe if it's still sitting this fall/winter the R20 gets traded in! Edit I think this one was sold. Sent from...

You are getting a pretty big upgrade.....

Thanks for the great info ID Sent from my iPhone using Tapatalk

Remember there are TWO parameters: Degree of list (rotation around the longitudinal axis) and draft of the hull (translation along the Z axis). You...

Nice write up. I subscribed too. Love engineer bubble heads.

How Toledo Batman! I have a RZ4, with about the equivalent lead weight but in with 6 jumbo batteries. I was always curious and thought it had to...

I am finally getting to the boat today and started it. Both batteries are sitting at 12.7 and 12.8. Start the boat no problem, but voltage gauge...